Need lenovo v15 ada bin file

[Kazuya]

I need lenovo v15 ada bin file to reprogram my bios chip, after i update my bios the screens turns black and no light on capslock key, when i turn on the laptop motor is spinning charging light is on also please help me fix this

 

[Laptechinfo]

I need lenovo v15 ada bin file to reprogram my bios chip, after i update my bios the screens turns black and no light on capslock key, when i turn on the laptop motor is spinning charging light is on also please help me fix this

We send you. Do you have old backup

 

[Kazuya]

We send you. Do you have old

We send you. Do you have old backup

Sorry i don't have a backup, can i get the backup with my laptop even it didn't display anything on screen?

 

[Laptechinfo]

@Kazuya have you programmed the bios using the programmer tool or by on operating system mode ?

 

[Laptechinfo]

@Kazuya

 

[Kazuya]

@Kazuya have you programmed the bios using the programmer tool or by on operating system mode ?

No i don't program it yet , i was only planing to program if i get my programmer

 

[Kazuya]

@Kazuya

Is this the bios bin?

 

[Laptechinfo]

Yes

 

[Laptechinfo]

Is this the bios bin?

Yes . Unzip it and program it

 

[Kazuya]

Yes . Unzip it and program it

Hello before i install the new bios bin do i required to backup my old corrupted bios bin?

 

[Laptechinfo]

Hello before i install the new bios bin do i required to backup my old corrupted bios bin?

yes make backup . that's must

 

[Laptechinfo]

yes make backup . that's must

have you done it? need any help?

 

[Kazuya]

I have problem the bios chip cannot be detected by the ch341a software

 

[Kazuya]

I think the clip is broken

 

[Laptechinfo]

I think the clip is broken

take out the chip and program it

 

[Kazuya]

I think the clip is broken

take out the chip and program it

I don't have tools to remove the chip

 

[Laptechinfo]

I don't have tools to remove the chip

solder iron you dont have?

 

[Kazuya]

solder iron you dont have?

I have

 

[Laptechinfo]

I have

Then use it. Use knife bit, if you have it or use chisel, then apply some low melt solder then gradually apply all legs and slowly lift it with tweezer.

 

[Laptechinfo]

@Kazuya don't force it.
It will come out when it's getting melting point..